Micro E-nail Kit for Dabs - 25mm by Crossing

The largest banger/ bucket setups commonly available. As such these require quite large dabs for effective use, much smaller than around 0.1g will provide a sub-par experience. 

These 25mm and 30mm axial e-nails with thick wall quartz bangers are mains powered beasts so are for home use only. They have accurate and stable temperature control so provide excellent quality vapour. Quartz is one of the preferred materials to vape from, being inert it provides clean accurate flavour profiles, this is enhanced here by the accurate temperature control. We rate this setup as one of the best for large dabs and sessions.  

The e-nail setup consists of a PID controller, a 220V AUS plug and a 220V round e-nail coil. These are used to heat the included quartz Banger (14mm male joint) with quartz insert to a high level of accuracy. Please note that if used, the quartz insert will settle to around20F below the temperature set on the controller after a 10 minute preheat, so this should be accounted for. SiC inserts will stabilise around 10-15F below the set temp but heat much faster and retain the heat better during use. 

The temperature range for the PID is 220-990F. My personal setup is 500F when using the insert and 460F without. 

General vaping temperature range is between 320-536F (160-280C) without insert and around 420-580F with Insert. Above this you're entering combustion... which is fine if that's what you're after! 

Heat time for this setup takes around 5 minutes to stabilise, no less when using the quartz insert, the box has an auto shut-off timer set to two hours. This timer can be increased to five hours, decreased to one hour or turned off entirely so your banger is always kept at the desired temperature (instructions below). 

As the temperature is constant this setup is ideal for session use, load it up and repeatedly hit it until the concentrate has been vapourised. Then wipe and repeat as desired.  

In The Box

• Enail controller box (1 year warranty - CE, ROHS certified) 
• 1.8m 220V power cable with plug 
• 1.2m Kevlar lined cable with axial E-nail (Stainless Steel coil) (6 month warranty)
• 25mm or 30mm Quartz Banger
• 14.4mm glass joints
• Quartz insert for Banger
• Directional Bubble Carb Cap
• 2 x Cotter pins to hold Banger in Place
• (Bubbler not included, displayed for illustrative purposes only)